标准状况


标准状况 （正體）

跳过字词转换说明

标准状况 (standard temperature and pressure, STP，常温常压)，简称“标况” 由于地表各处的温度、压强皆不同，即使是同一地点的温度压强也随测量时间不同而相异，因此为研究方便，制定出描述物质特征的标准状况：0 ℃（273.15 K）、100kPa，这样的定义接近海平面上水的冰点。1摩尔的理想气体在STP下占有的体积为22.413996(39) L(CODATA 2002)，为标准摩尔体积 (standard molar volume)。这是区别一般条件而制定的标准。

历史上由巴黎制定的通行欧洲的旧制标准如下：

  • 压强 p = 1 atm = 101325 帕斯卡 = 1013.25 hPa = 101.325 kPa = 1.01325 bar
  • 温度 T = 298.15 K ≙ 25 °C ，空气密度 ρ = 1.184 kg/m³.
现在也使用T = 293.15 K ≙ 20 °C 空气密度 ρ = 1.204 kg/m³.

在化学和生物化学中另外还包括定义的观察反应物浓度，一般情况下为1mol/L (1 M)。在生物化学中只有质子例外（H+）。限定pH为7，即10-7 mol/l H+离子浓度用于准生理条件描述，肌体条件，细胞内部条件等。

标准状况参考条件
温度 绝对压力 相对湿度 出版或创立者
°C kPa % RH
0 100.000   IUPAC（正在使用的定义）
0 101.325   IUPAC（以前使用的定义）NIST[1], ISO 10780[2]
15 101.325 0[3][4] ICAO's ISA，[3] ISO 13443,[4] EEA,[5] EGIA[6]
20 101.325   EPA，[7] NIST[8]
25 101.325   EPA[9]
25 100.000   SATP[10]
20 100.000 0 CAGI[11]
15 100.000   SPE[12]
°F psi  % RH
60 14.696   SPE,[12] U.S. OSHA,[13] SCAQMD[14]
60 14.73   EGIA,[6] OPEC,[15] U.S. EIA[16]
59 14.503 78 U.S. Army Standard Metro[17][18]
59 14.696 60 ISO 2314, ISO 3977-2[19]
°F in Hg  % RH
70 29.92 0 AMCA，[20][21] air density = 0.075 lbm/ft³. This AMCA standard applies only to air.

注释：

  • EGIA：加拿大电力和燃气检验法
  • SATP：标准的环境压力和温度
  • SCAQMD：加州南海岸空气质量管理区

参看

参考资料

  1. ^ NIST（1989年）．NIST Standard Reference Database 7 – NIST Electron and Positron Stopping Powers of Materials Database．于2008年7月25日查阅．原文：“If you want the program to treat the material as an ideal gas, the density will be assumed given by M/V, where M is the gram molecular weight of the gas and V is the mol volume of 22414 cm3 at standard conditions (0 deg C and 1 atm).”
  2. ^ ISO (1994), ISO 10780:1994 : Stationary source emissions - Measurement of velocity and volume flowrate of gas streams in ducts
  3. ^ 3.0 3.1 Robert C. Weast (Editor)（1975年）．Handbook of Physics and Chemistry，56th Edition，CRC Press，F201–F206．ISBN 0-87819-455-X． 
  4. ^ 4.0 4.1 "Natural gas – Standard reference conditions", ISO 13443, International Organization for Standardization, Geneva, Switzerland  ISO Standards Catalogue
  5. ^ "Extraction, First Treatment and Loading of Liquid & Gaseous Fossil Fuels", Emission Inventory Guidebook B521, Activities 050201 - 050303, September 1999, European Environmental Agency, Copenhagen, Denmark  Emission Inventory Guidebook
  6. ^ 6.0 6.1 "Electricity and Gas Inspection Act", SOR/86-131 (defines a set of standard conditions for Imperial units and a different set for metric units)  Canadian Laws
  7. ^ "Standards of Performance for New Sources", 40 CFR--Protection of the Environment, Chapter I, Part 60, Section 60.2, 1990  New Source Performance Standards
  8. ^ "Design and Uncertainty for a PVTt Gas Flow Standard", Journal of Research of the National Institute of Standards and Technology, Vol.108, Number 1, 2003  NIST Journal
  9. ^ "National Primary and Secondary Ambient Air Quality Standards", 40 CFR--Protection of the Environment, Chapter I, Part 50, Section 50.3, 1998  National Ambient Air Standards
  10. ^ "Table of Chemical Thermodynamic Properties", National Bureau of Standards (NBS), Journal of Physics and Chemical Reference Data, 1982, Vol. 11, Supplement 2.
  11. ^ "Glossary", 2002, Compressed Air and Gas Institute, Cleveland, OH, USA  Glossary
  12. ^ 12.0 12.1 The SI Metric System of Units and SPE Metric Standard 1984, Richardson, TX, USA (Notes for Table 2.3 on page 25 define standard cubic foot and standard cubic meter)
  13. ^ "Storage and Handling of Liquefied Petroleum Gases" and "Storage and Handling of Anhydrous Ammonia", 29 CFR--Labor, Chapter XVII--Occupational Safety and Health Administration, Part 1910, Sect. 1910.110 and 1910.111, 1993  Storage/Handling of LPG
  14. ^ "Rule 102, Definition of Terms (Standard Conditions)", Amended December 2004, South Coast Air Quality Management District, Los Angeles, California, USA  SCAQMD Rule 102
  15. ^ "Annual Statistical Bulletin", 2004, Editor-in-chief: Dr. Omar Ibrahim, Organization of the Petroleum Exporting Countries, Vienna, Austria  OPEC Statistical Bulletin
  16. ^ "Natural Gas Annual 2004", DOE/EIA-0131(04), December 2005, U.S. Department of Energy, Energy Information Administration, Washington, D.C., USA  Natural Gas Annual 2004
  17. ^ Sierra Bullets L.P.．“Chapter 3 – Effects of Altitude and Atmospheric Conditions”，Rifle and Handgun Reloading Manual, 5th Edition． "Effects of Altitude and Atmospheric Conditions", Exterior Ballistics Section, Sierra's "Rifle and Handgun Reloading Manual, 5th Edition", Sedalia, MO, USA  Exterior Ballistics
  18. ^ The pressure is specified as 750 mmHg. However, the mmHg is temperature dependant, as mercury expands as temperature goes up. Here the values for the 0-20°C range are given.
  19. ^ "Gas turbines – Procurement – Part 2: Standard reference conditions and ratings", ISO 3977-2:1997 and "Gas turbines - Acceptance tests", ISO 2314:1989, Edition 2, International Organization for Standardization, Geneva, Switzerland ISO
  20. ^ ANSI/AMCA Standard 210, "Laboratory Methods Of Testing Fans for Aerodynamic Performance Rating", as implied here: http://www.greenheck.com/pdf/centrifugal/Plug.pdf when accessed on October 17, 2007
  21. ^ The standard is given as 29.92 inHg at an unspecified temperature. This most likely corresponds to a standard pressure of 101.325 kPa, converted into ~29.921 inHg at 32 °F)

外部链接

性





stock | retire | vm
Why are we here?
All text is available under the terms of the GNU Free Documentation License
This page is cache of Wikipedia. History